Kramer-electronics RC-43T Uživatelský manuál stáhnout pdf (Strana 15)

RC-43T - Connecting the RC-43T

 Connect pin 3 on the K-NET connector to pin 3 on the room controller K-NET

connector (B to B)

 Connect pin 4 on the K-NET connector to pin 4 on the room controller K-NET

connector (G to G)

5.2 Terminating the K-NET Bus

The devices at both ends of the K-NET bus must be terminated.

Figure 9: RC-43T K-Net Bus Termination Switch US Version

Figure 10: RC-43T K-Net Bus Termination Switch EU Version

To terminate the K-NET bus on the RC-43T:

 Slide SW7 (see SW7) into the position shown in Figure 9 (US version) or

Figure 10 (EU version)

5.3 Installing the Configuration Software

Download the K-Config configuration software from our Web site and install it

(refer to the K-Config User Manual).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Žádné komentáře

Kramer-electronics RC-43T Uživatelský manuál Strana 15