Kramer-electronics PT-102S Uživatelský manuál stáhnout pdf (Strana 8)

Using the PT102VN 1:2 Video DA

KRAMER ELECTRONICS, LTD.

4 Using the PT102VN 1:2 Video DA

You can connect your PT102VN:

 As a 1:2 video DA (see section 4.1)

 To a 4x1VB 4x1 High Resolution Video Switcher to increase the number

of inputs (see section 4.2)

 To two 105VB 1:5 High Resolution Video DA units to increase the

number of outputs (see section 4.3)

Note: similar principles apply when using the PT102A or the PT102S.

4.1 Connecting the PT102VN 1:2 Video DA

To connect the PT102VN 1:2 Video DA, as the example in Figure 4

illustrates, connect the following

1. Connect a composite video source (for example, a VCR) to the INPUT

BNC connector.

2. Connect the 2 OUT BNC connectors to up to 2 composite video

acceptors, as follows:

 Connect the OUT 1 connector to video acceptor 1 (for example, a projector)

 Connect the OUT 2 connector to video acceptor 2 (for example, a monitor)

3. Connect the 12V DC power adapter to the power socket and connect the

adapter to the mains electricity.

4. Adjust the output signal level and/or cable compensation equalization

level, if required.

Figure 4: Connecting the PT102VN 1:2 Video DA

1 Switch OFF the power on each device before connecting it to your PT102VN. After connecting your PT102VN, switch on

its power and then switch on the power on each device

1 2 3 4 5 6 7 8 9 10 11 12 13

Žádné komentáře

Kramer-electronics PT-102S Uživatelský manuál Strana 8