Kramer Electronics VP-417 Uživatelský manuál Strana 9

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 13
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 8
Operating the VP-417 Video to PC/HD/DVI Scaler
7
7
6.2 Using the OSD
You can use the OSD to set a wide variety of parameters.
When using the OSD, the front panel buttons operate in the following manner:
MENU: Opens the OSD main menu (see
Table 4). Press a second time to
close the OSD
ENTER: Selects the highlighted menu option or parameter
: Steps up through the menu options or decrements a parameter value
+ : Steps down through the menu options or increments a parameter value
Example of Setting a Parameter
The following steps are an example of setting parameters to increase the saturation
on the display:
1. From normal operation
1
2. Press the + or button to highlight SATURATION.
SATURATION changes to green when highlighted.
, press MENU.
The OSD Main Menu appears on the screen.
3. Press ENTER.
The saturation parameter changes to red.
4. Press the + button to increase the value or the button to decrease the value.
5. Press ENTER to set the value.
The saturation parameter changes to white.
6. To return to normal operation, either:
Press MENU
Wait until the menu times out automatically
6.2.1 The Main Menu
Table 4 defines the Main Menu parameters and functions.
Table 4: The Main Menu Parameters and Functions
Parameter Function Value Range Factory
Default
CONTRAST Adjusts the contrast 0 to 255 128
BRIGHTNESS Adjusts the brightness 0 to 255 128
SATURATION Adjusts the saturation 0 to 255 128
HUE Adjusts the hue -128 to 128 (Not available in PAL) 000
AUTO SYNC OFF Turns auto sync on/off
2
ON/OFF OFF
ASPECT RATIO Adjusts the aspect ratio of the
output
FULL/4:3/16:9 FULL
OVER SCANNING Adjusts the over scanning value OFF/5%/10%/15%/20% 5%
NOISE REDUCTION Adjusts the noise reduction filter Off/Typ/Min/Max Typ
1 That is, the user is not within the OSD menu
2 When on, the VP-417 disables its output syncs after a few minutes when no input source is detected. This feature is useful for
applications where the projector should automatically shut down when no source is present
Zobrazit stránku 8
1 2 3 4 5 6 7 8 9 10 11 12 13

Komentáře k této Příručce

Žádné komentáře